Ford approves two new brake bleeders from Phoenix Systems

St. George, UT: Phoenix Systems is introducing two newly Ford-approved reverse brake and clutch bleeders. Both offer one-person operation and bleed all brake and clutch systems in approximately ten minutes, including ABS.

Bleeding means removing trapped air and reverse bleeding means attaching the bleeder to a brake caliper bleed screw and simply pushing the air—and old fluid—in reverse flow up through the brake lines and out through the master cylinder. The bleeder pump draws in fresh fluid each time the handle is released.

The larger of these two patented bleeders, the Heavy Duty brake bleeder (PN 2002HD-Ford) is made of metal, carries a two-year warranty, and is endowed with 20ml increased capacity for faster, more efficient bleeding.

The Medium Duty brake bleeder (PN 2003-Ford) provides all the bleeding capabilities of the heavy-duty version but at a lower cost. This bleeder is constructed from high-strength Zytel nylon polymer and, like the Heavy Duty, fits all vehicle makes and models, including motorcycles and military vehicles.

Portable, lightweight and complete, these bleeding kits require neither electricity nor air—nor special tools or clips to bleeds ABS.

For further information contact:

Phoenix Systems, LLC

1076 East Commerce Dr. Suite 400,

St. George, UT 84790

Telephone (888) 749-7977 or e-mail JT@brakebleeder.com or visit: www.brakebleeder.com

Editors’ Contact: Victor Moore (706) 531-0058 or Vic@MooreGoodInk.com

—End—